==== How to connect the IKEM coil ====

  - Ordered List ItemTurn off the gradients (green switch in the middle case in the technical room)
  - Ordered List ItemRemove the volume coil if connected and disconnect the red labeled cable
  - Connect the orange labeled cable from the RF Interface Adapter
  - Ordered List Item Open the electronic case at the MR bore (left case)
     * Turn off the black switch (under the green lights)
     * Disconnect the first round connector (Power Supply)
     * Connect this cable with male cable from the RF Interface Adapter
     * Connect female cable from the RF Interface Adapter into the Power Supply
     * Turn on the black switch
  - Connect the gray cable into the RF Interface Adapter in the Low Power
  - Turn on the gradients
  - Before measuring, the active coil configuration has to be set (Scan Control -> Scanner -> Change Active Coil Configuration -> IKEMspinal)